Family Wall Piece

A Christmas present I made in the makerspace this quarter is a family wall piece. The first thing that I did was find a picture of two branches with leaves. I wanted two branches so that I could do two layers and have the branches overlap each other. After I found the picture I made it so that it was only the outline of it. None of the leaves were connected to the branch after this so I had to individually connect all of the leaves to the branch. After, I connected the branches to a border. I then created the hanging names. I had to delete all of the parts that the hanging part was going through the branch so that it would not cut off anything, this part took a long time. After this, I put “KEY FAMILY” in the back layer. After cutting it out I wood-glued both of the frames together. This project turned out very well. If I were to do something different about it I would make it a little bigger.